Dynatech HP7000 2x3600W RMS@2 Ohm Class H Amplifier - Each
Dynatech's HP-7000 power amplifiers are built around robust and advanced toroidal transformers, and deliver clean power on demand. The advanced protection circuitry guards against short circuit, over load, clip limit, peak current limit, over heat and open circuit, and also protects against ultrasonic and RF interference.
A high current power supply increases reliability and performance. Other features include center-detented gain controls, input peak limiter and fast recovery to ensure low distortion. The variable speed fans effectively cool the amp and protect against overheating. Input is through XLR or 1/4" connectors, while you can use Speakon-type or binding post connectors for output.
Dynatech HP-7000 Amplifiers are specially designed for professionals who value high power, audio clarity, reliability and lasting performance.
Specification
- Output Power 8Ω stereo 1450W x 2 4Ω stereo 2250W x 2 2Ω stereo 3600W x 2 8Ω bridge 4500W 4Ω bridge 7200W
- Frequency Response 20Hz-20kHz, +0/-0.5dB
- THD+N <0.5%
- S/N rate (A Weighted) ≥96dB
- Damping Factor >1200
- Crosstalk ≥60dB
- Slew rate >40V/µs
- Input sensitivity 0.775V/1V/32dB
- Input impedance (bal/unbal) 20kΩ/10kΩ
- Voltage gain 43.4dB
- Cooling Air flow from front to rear
- Protection Soft start, VHF, DC, short circuit, over load, clip limit, peak current limit over heat, progressive volume
- Input Balance input XLR-F, Balance output XLR-M
- Output Two red and black binding posts. NL4 speakon
- Front panel indicator Rock power switch / independent channel volume control knob/ power indicator /signal indicator / clipping indicator / protection instructions
- Rear panel indicator Stereo/parallel/bridge mode selector switch, sensitivity selector switch, soft cut switch
Product dimension (mm) 483 x 503 x 133 (3U) - Packaging dimension (mm) 620 x 585 x 210 (3U)
- Net weight 36.8 kgs
- Gross weight 40 kgs
